Having problems with your Air Conditioners ?

Sunbeam mixer model 1940

\015 The speed control does not always shut off and a few times the speed went from slow to high speed on its own.\015

Answers :

Remote problem change remote

Repair Help & Product Troubleshooting for Air Conditioners
You need a second opinion or clarification ? ask it in the comment box OR you can Ask Your Own Question

Tips for a great answer:

  • Please provide as much detail as possible as this will allow our members to better understand and respond to your Comment
  • If you need clarification, ask it in the comment box
  • It's 100% free, no registration required

Suggested Questions/Answers :

It is recommended you read all this kind of situations

Sunbeam mixer model 1940


Remote problem change remote ... Air Conditioners

Sunbeam Model No. SCK 14200 DR no cooling...


Un plug a/c from wall and remove the screws from the electrical compartment of the unit and locate the thermostat, remove the 2 wires of the thermostat and use ohms meter to check the part for continuity, if you dont have continuity with t-stat turne ... Sunbeam SCA103RWB1 Room Air Conditioner

Carrier heat pump (basic model) runs at 0 or below


A basic model heat pump with an air handler with electric strip heat generally will continue to run with a call for heat regardless of the outdoor air temperature unless there was an outdoor thermostat (an accessory) installed. There is still heat in ... Carrier 38CKC036 Air Conditioner

Have sunbeam sck6000dr model portable ac unit, we cannot find the remote and cannot get it to operate without it? please help our home ac just went out! thank you :)


... Air Conditioners

Replacement fan motor sunbeam model # SCA103RWB1


... Sunbeam SCA103RWB1 Room Air Conditioner

Sunbeam ac Model # SCA103RWC1 i dont have the manual or remote but i want to know how i can have it shout off after a while so its not on 24hours a day


You can solve your problem with 2 ways:\015\012\015\012Buy a universal a/c remote control. If yours is in the list that the universal remote control can support that's better. Set up your new remote control as the guide des ... Sunbeam Air Conditioners

I have a sunbeam electric blanket the main control Model P85KQA, that blinks 88 on the main controller.


... Air Conditioners

We have a Dayton Electric thermostat model # 2E215 in our master bath, controlling the under-the-floor, hot water, heating in the room. There's an adjustment under the cover re "cycle time" that goes from essentially 0 to about 1.0 - and a counter-clockwise arrow to adjust from the smaller number to the larger. Our winters here (Vail, CO) can get very cold, and I'm wondering what is the best cycle setting to use keep the temperature as close to the desired temperature in the room. Thank y


... Dayton Air Conditioners

Hi, I had a Cozy gas-fired room heater installed two years ago. It has only been used during the winter months. When it was installed , it passed the carbon monoxide test (0 parts per million). I had it checked today, and it failed the test, and the gas specialist said it might have to be condemned. Also, he said that 5 of 6 similar Cozy heaters that were fairly new failed testing this season. Have you heard about Cozy heaters having a similar problem? What can I do? Model: VC351A-H 3


Hi,A very common problem with the unvented heaters is that they get dust and dirt in them and then they do not burn right. The pilot is especially bad and often that will make them burn bad failing the test.Before throwing it out I would ... Air Conditioners

I have a 1993 Model SRHF48U01A (The 0 might be a O (zero) When the thermostat calls for cooling, the inside unit (fan) starts up and continues to run but the outside unit wants to start (it comes on for a second and then trips the breaker that is located behind the outside unit. I can turn the breakers off that are inside the house and let them stay off for a short time and then reset the outside breaker and then turn the inside breakers on and the unit starts and continues to run until the te


Well the trouble is surely at the compressor side. Dont know what kind of repair man you invited. He should have atleast diagnosed the problem. Following can be the causes\015\012\015\0121. Capacitor is slightly faulty (As you said). If t ... Amana Air Conditioners

Temperature light shows"0" will not respond to pressing the diamond-shaped button, green "on" light is off, no hot water. Model# is W7P


Can you give some more details how this happent and which is the brand and model of your AC ... Air Conditioners

I have a Dyna-Glo pro model # is RMC-KFA170TDGP. The fan comes on and the ingniter is flaming. the fan runs for about 20 seconds and the digital temperature screen reads E1. The presure gauge in the back is at 0.


CFM Corporation\015\012 102 S 29th Street\015\012 Blackwell, OK 74631\015\012 Phone: (580) 363-2850\015\012 Fax: (580) 363-1662 ... Air Conditioners

I am trying to locate the on/off knob for a sunbeam model # sca052mwb1 air conditioner


... Sunbeam SCA052MWC1 Air Conditioner

My queen size electric blanket... one side the control is flashing 'E' sunbeam 658 model BL 445D Why is this happening and can it be rectified?


Hi!!Here is some of the frecuent questions regarding "F" flashing on the Temp. Controls. Clicking on the following link will take you to the Owners Manual Page for Sunbeam Electric Blankets.\015\012\015\012If you need additio ... Air Conditioners

I have a Carrier Weathermaker Infinity furnace model 58MVP100-F-1-20 with 3 zones and Carrier Comfort Zone II programable thermostat. I recently installed ageothermal heat pump system which includes a hot water coil in the furnace plennum. The heat pump is sized to meet loads except for the coldest days of winter - (below 0 F) - when the gas furnace is expected to kick in. My problem appears to be the Weathermaker's characteristics don't accommodate the low heat /slow response provided by


Http://www.hvac-talk.com/vbb/archive/index.php?t-85094.html here is a site i found very useful ... Carrier Air Conditioners

Rheem Air Handler will not run. This is a 2006 Rheem model RHLA-HM3617JA Air Handler. I replaced both the condenser and air handler circuit boards. I replaced the motor in the air handler.. The condenser works fine, the board flashes normal. The air handler board shows 0 volts on the X13Com brown lead,..28 Volts on the center, X13G green/black lead, 1 volt on the Bottom, Blue, X13SPD terminal. The 24VAC Terminal shows 27 volts. The 3 amp fuse is good. The transformer appears normal. I replaced


Have you hard wired your fan motor to verify that the motor and or the capacitor are good? If you do a continuity test of the motor leads(with electricity off of course) you can see if the motor has open or grounded windings. ... Ruud Handler Air Conditioner

Daikin unit displaying a message of Unit 0, the eye symbol and E3 The model is Daikin BRC1D61. The operation light also flashes. What's wrong with it?


... Cfm Daikin R410a Split System Air Conditioner

Hi, I have an older model of micro furnace made by Pelco I am having difficulties finding the service manual or the schematics for it. The fan works howversome of the caps have dried out on the circuit board and one of them is cracked I can not see the value. If you have a circuit as it is similar to the sunbeam. Can you help. Thanks, Ben


I am afraid if this is still available. I have one hardcopy but now it is not readable, scanning will not do and the copy is very old and badly damaged. Sorry that I can't help you on this. Anyway I wish you good luck ... Sunbeam Air Conditioners

Rheem Air Handler will not run. This is a 2006 Rheem model RHLA-HM3617JA Air Handler. I replaced both the condenser and air handler circuit boards. I replaced the motor in the air handler.. The condenser works fine, the board flashes normal. The air handler board shows 0 volts on the X13Com brown lead,..28 Volts on the center, X13G green/black lead, 1 volt on the Bottom, Blue, X13SPD terminal. The 24VAC Terminal shows 27 volts. The 3 amp fuse is good. The transformer appears normal. I replaced


We tried to bypass at the Tstat. Thanks for your time and interest. ... Air Conditioners

Sunbeam portable air conditioner leaking water on carpet - receptacle is in place. ?model ta-08mb?


... Polaroid Sunbeam 10,000 BTU Portable Air Conditioner

I have a Sunbeam model 1388 warm mist vaporizer and the instructions are rather vague as to where the medicine well is located. It states that is directly in front if the steam outlet however all that is there is a shallow grill. Is that the medicine well? A clear photo or diagram showing exactly where the medicine well is at would be helpful but none seems to exist. Can you help?


According to operators manual Add liquid vaporizing inhalant only to the medicine \015\012 well in front of the steam outlet (See Figure 3). picture is not very clear but should be the only area in front of steam out let. Hope this helps. ... Sunbeam Air Conditioners

My portable a/c continues to leak water from the bottom when in use. I have a hose attached to the spout in the back, but it still leaves a puddle and almost nothing drains out the back. It's a sunbeam sca102rpc1, 10,000 btu model. I have the unit level on a few 2x4's off the ground, so the drain off from the spout is all down hill. but yet the unit must be leaking because the water is in a puddle at the bottom under the unit, not the drain pan.


It sound like the coil inside could be dirty. I have had the same problem with air handlers, when the coil is dirty or the filter is dirty it creates a back pressure and causes the condensation to drip off away from the condensation pan. ... Sunbeam SCA102RPC1 Portable Air Conditioner

I need to clean the dust, mold, etc., from the fan blade and surroundings of my Sunbeam evaporative humidifier Model #1118. How do I get the top or bottom off it? Thanks.


... Sunbeam Air Conditioners

Replacement remote for Sunbeam electric fireplace model #fl28-R


... Air Conditioners

Need a condenser fan for sunbeam air conditioner model sck7500dr part number 30402100001


... Sunbeam Air Conditioners

A detailed question is important to get you a relevant answers

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
all rights reserved to the respective owners || www.ad-trader.net || Terms of Use || Contact || Privacy Policy
Load time: 0.0515 seconds