Having problems with your Air Conditioners ?

Condensor? There was a build up of water in the tray and I heard the fan in the back going through it. I had to drill a hole to drain the water because there was not one. It is know much quieter and running better except that the condensor or motor does not kick in even when set to 60 degrees. I waited the 3 minutes still nothing. It just runs in fan mode even when on cool.


Answers :

It probably shut off on high pressure. Let it cool down, plug your hole that you drilled and give it another try. The water is suppose to collect there and the fan is suppose to throw it into the condenser to keep it cooler and make it run more efficiently. Good Luck,

\015\012\015\012

kstfas

Repair Help & Product Troubleshooting for Air Conditioners
You need a second opinion or clarification ? ask it in the comment box OR you can Ask Your Own Question

Tips for a great answer:

  • Please provide as much detail as possible as this will allow our members to better understand and respond to your Comment
  • If you need clarification, ask it in the comment box
  • It's 100% free, no registration required

Suggested Questions/Answers :

It is recommended you read all this kind of situations

Condensor? There was a build up of water in the tray and I heard the fan in the back going through it. I had to drill a hole to drain the water because there was not one. It is know much quieter and running better except that the condensor or motor does not kick in even when set to 60 degrees. I waited the 3 minutes still nothing. It just runs in fan mode even when on cool.


It probably shut off on high pressure. Let it cool down, plug your hole that you drilled and give it another try. The water is suppose to collect there and the fan is suppose to throw it into the ... Frigidaire FAH106N1 Wall/Window Air Conditioner

Have a RHEEM Central air/heat system.Model: 13AJN36A01All works well, except when my heat is on, if I switch the fan on the thermostat from AUTO to ON, my condensor unit outside kicks on. Looked up this model and it doesn't contain a heat pump so I don't believe it should ever kick on the condensor unit when the heat is on (regardless of fan setting).


Thermostat is wired wrong on terminals or at inside unit. It could be heat pump ... Rheem 13AJN36A01 3 Ton 13 SEER Air Conditioner

Thermostat inside went up to 78 degrees which was set for 73 degrees. I checked filter filter was clogged. I cleaned filter. However could not get outside unit fan to go on even after turning off for 20 min. Also circut breaker was turned off and back on.


DID CIRCUIT BREAKER TURNED OFF BY ITSELF?\015\012If it is, there was too much circuit load, or compressor might be too hot.\015\0122. check outside unit fan, fan capacitor and compressor capacitor and CONTACT SWITCH.\015\012FAN IS A ... Air Conditioners

I have an lg artcool unit with model numger LSV244VM-4 on the outdoor unit.The ambient temperture is around 15 degrees celcius today so i set the controls for 30 degrees cecius to ask the unit to heat.The indoor unit responds by sending power to the outdoor unit but neither gthe compressor or the condensor fan turn on.The customer told me that "C6" keeps apearing on the remote although this did not occur while i was attending.There is something in the control circuit of the outdoor unit that is


Check for 240 voltsto the contactor! ... Air Conditioners

Air conditioner I have a Honeywell air conditioner unit. For the last several days it has failed to cool down to the temp I set except at night. When I came in this evening it was 87 degrees in the house. I went to the main unit in the garage and flipped the fuse buttons to off and then back on. Then I dd the same at the main fuse box for the house. (Dont ask me why I thought this would help). Now I can't get the unit to turn on at all. Any ideas?


Yes, first turn your thermostat to the off position. Try to reset both fuse boxes again. If the ac comes back on problem solved, if not fuses and or breakers may need to be replaced.\015\012\015\012Let me know if this helps and we can go futher into ... Haier Energy Star ESA3183 Air Conditioner

Room temp stays at 76 and will not get any colder even though unit seems to operate and compressor sounds like it turns on and fan blows and water drains . it is set to 60. room is about 300 sq ft


Hi,\015\012From what you are describing the unit is working perfectly...You just have alot of heat infiltration and the best that unit can do is 76....\015\012If you want or need it cooler you will need to buy a larger size unit...\ ... Maytag M6P09S2ACOM Air Conditioner

I have a Dometic 15,000 btu, ducted air conditioner in my 30 ft fifth wheel. It seems like the unit has never cooled very efficiently. Dealer has checked out. I noticed yesterday, outside air over 100 degrees, that the air conditioner would put out good flow of cool air, but once in a while compressor would stop running even though not close to thermo setting. Fan would continue running. Any suggestions?


Not sure what the pressure sensor should ohm at but i would suspect a faulty sensor if everything else checks out. Its very common for these sensors to exhibit issues when they get hot. Also you may have a filter in the system that may be restricte ... Dometic Rooftop RV Air Conditioner

Carrier unit runs all the time, never shuts down and the fan in the house will not shut off ' the house isnt getting beloe 80 degrees inside, even though I have the thermostat set at 76, I turned the thermostat on 70 about an hour ago and the temp inside still isnt falling


Ya need preventive maintenance preformed evaporator clean condenser cleaned and the blower wheel clean unit could be under charged have it tuned up and your electric bill wont surprise you leave it running like it is and you will have a very large b ... Air Conditioners

When I switch the T-stat to (fan on) the blower won't come on unless I move the Fan limit up close to the 100 degree mark and then I move that limit back down close to 130-135 degree and after approx. 10 seconds blower shuts off. I'm not sure where that fan limit is supposed to be set at, it was originally set around 130-135. It's a 2 wire limit and the range is 100-140. I know the stat is sending signal, I get 24v on green term. at fan center relay. Thanks, Dave


To help you we need more info. What thermostat and what furnace or air handler. There are two circuits involved. One is the green wire or g terminal that switches the fan relay into high speed for ac. The other is the w white that actuates the fan cy ... Air Conditioners

Our thermostat is set at hold with the fan on auto. The house and cool temp is set at 75 degrees, yet the fan will stay on CONTINUOUSLY unless I manually take down the temperature OR the outside temp falls below 75 degrees over a several hour period. This can't be efficient? HELP!


It is ok to run your fan continously. constant air filtering as long as it pauses before a/c cycles on. will not use any more electricity than a toaster. is there a fan programing feature on t-stat. if so you will need to turn programing to fan o ... Amana Air Conditioners

I just moved into a new place and it has the RTH230B thermostat installed. I turned on the furnace, set the thermostat to "Heat" then the fan to "Auto" and used the up and down arrows to set the temp to 72 degrees. The temperature seemed fine for the first hour or so. However, the heat and fan stays on full power and continued to heat at full power well into 80 degrees on the thermostat screen. I could only shut it off by turning off the actual furnace switch. I first tried reducing the temper


From what you learned from your neighbor, I would say no. Certainly, sounds like a manufacturing defect to me. ... Air Conditioners

I just bought a house that has a Lochinvar heating boiler RB945-RB500 PKG-7002. Ive heard it has never heated the space adequately. Today I looked at the water temp setting in the control box and found that it was set at about 200 degrees. However the best I can tell the actual water temperature never gets above 130 degrees according to the meter on the boiler's side.. What is my problem?


Hi,\015\012Not finding that exact model number...but...\015\012I think what you have is a modulating boiler that also varies the water temperature based on the outdoor temperatures...\015\012Because of that what you are seeing is th ... Air Conditioners

My bonaire evaporative cooler cycles from high to low fan speeds when set in the cool mode. It works fine at the required speed setting when just the fan (no water) is selected. It also dumps water immediatly the cooling cycle is turned off rather than holding it for about 40Min as it should. Sounds like a controller problem, but I'm not sure if it would be the touch pad or the board up on the roof mounted unit.


... Air Conditioners

Air conditioner/furnace was working for the past few months. Came home today at it is at 81 degrees, although my set temperature was set at 72 degrees. Temperature is rising to 83 degrees and I can't figure out why the air conditioner won't run properly. I turned the fan on from auto to on and it's blowing warm air. The default scree on reads the current temperature at 82 degrees with a circle and snow flake above it and an downward arrow where the word room is written. Any suggestions? I t


Check outside breakers. Open up outside panel and see if contactor is pulled in. If so you have a voltage problem or a bad capacitor. Sometimes a wire burns off. So look for this. If you have a float switch on the inside unit it may be tripped. Stopp ... Air Conditioners

My laser 30 temperature setting does not work. I have it set at 68 degrees and the temperatur rises to 78 degrees. The pot burner does not shut off at all. It keeps burning even through the night k


... Air Conditioners

Have an oil fired boiler for baseboard heat and it also has a tankless heater for domestic hot water. No heat being called for only getting hot water for use. Boiler goes to 210 degrees before it knocks off. It seem to push hot water through baseboard eventhough not calling for it. The controls are set to high limit 160 degrees


These boilers usually have multiple controls. The control that would take it out of the circuit at 210 degrees is a safety. \015\012\015\012You should definitely have a professional take a look at this unit before you continue using it. ... Air Conditioners

Hi there, I just moved into a new house with this heating system. I have it on winter mode to heat water for showers etc but the last 3 days the water is still luke warm.. i have tried the extra hot water function for a day but nothing happens.Is there a particular setting it has to be on or does the fan speed need to be at a certain setting? thanks, Sarah.


There should be an access panel on the water heater.Take it off and check the temperature setting.If there is insulation covering it,just cut a **** in it,about near the middle toward the front side facing out from where it is,or it could be on the s ... Air Conditioners

Our total line thermostat was set on 73 degrees and all of a sudden it went to 99 degrees and I counld not turn it off, it just kept running. So I turned off the breaker and turned in back on and now I can't set the temperature. It's just set on 99 and won't do anything. When I turn the fan on, the air won't get cold.


Hi, it sounds as though you have a faulty thermostat that failed before your eyes. The circuitry in the sub-base has failed. If the stat is set in the off posistion and you turn the fan switch on, just the fan will run. If it is on cool and you turn ... Air Conditioners

I have an old Kenmore window unit that looks like a 72055 (control panel on top left). Although I have it set at 90 degrees and the room temperature is 75, the fan cycles on and off. How can I set it so than neither the fan nor the cooling comes until the set temperature is reached?


Most have a 'continious \012\012 mode' that operates the air moving fan whenever the unit is on, or a 'cycling mode' that operates from a temp sensor usually near the input over the evaporator coil.Look for the instruction for setting the mode ... Air Conditioners

My ac unit will not go below 77 degrees. It quit working about 1.5 weeks ago, and I had a service technican come and look at it. He replaced the capacitor and the unit started back up and would cool to 75 degrees (where I usually have it set). He checked the pressure of the unit as well and said that it was fine. However I came back from a trip and the thermostat read 77 degrees even though I have it set on 75, and the temperature will not go any lower. This is the same thing it was doing


Hi, It sounds to me like you have covered all of the basis. The evaporator coil should be clean if you keep your filter clean and the condensation is showing that it is cooling properly. Normally, when the temperature increases outside, you will loos ... Air Conditioners

1998 rover 214. after few mins of switching car on, the water bottle will start to bubble like mad,and its like a creamy gunge,if i switch my heaters on, the heaters stay cold and the bubbling in water bottle gets violantly worse,(even banging the bottle with the pressure).The temp gauge will stay at half way even though fan kicks in,but it will go up to the red if i drive.


This sounds like you have an air bubble in your system, I would pressure test for leaks. The creamy grunge sounds like oil in the coolant...if that is the case, exploritory surgery is the next step. ... Air Conditioners

Ruud furnace Model UGPH-10EBRJR Silhouette ll. blower fan stays on continously, (also draft blower) and the only way it will shut off is to disconnect power. I've replaced thermostat, fan limiter switch, switch on the blower housing, even replace circuit board (IFC). I've even disconnected the thermostat wires to circuit board and blower still comes on as aoon as power is connected. I've disconnected everything on the circuit board except for blower wires and 24 volt transformer and it still com


... Air Conditioners

I have installed a UPM model THM101B thermostat on my Intertherm model E3EB-015H electric furnace. I wanted the feature of turning the blower "ON" without the heating elements. I picked up the green 12v for the fan relay. Once the power is restored the furnace comes on even though the temp setting is low and the only way I can turn the furnace off is by disconnecting the green fan relay wire? The jumper has been properly set in the new thermostat for electric furnace operation.Right now I feel t


... Intertherm Air Conditioners

I can't get my a/c to work. I have a totaline residential thermostat P/N P374-1700. I set the thermostat to cooling only and set the temperature to 72 degrees and while the house is 75 degrees and the green light goes on, nothing happens. The fan doesn't run either. I have HVAC on both the lower floor of the house and a separate station on the upper floor. The upper floor station works. The lower floor station worked fine earlier today, but nothing now. Any suggestions.


... Carrier Air Conditioners

I have a miysubishi mr slim msh12en heat pump in one part of my house i have the remote set to 89 degrees but the heat or fan or outdoor unit is unresponsive the only thing i can see is a defrost light asnd power light on the blower unit i switch over to ac still set at 89 degrees and the ac works why


... Mitsubishi Air Conditioners

A detailed question is important to get you a relevant answers

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
all rights reserved to the respective owners || www.ad-trader.net || Terms of Use || Contact || Privacy Policy
Load time: 0.0866 seconds