Having problems with your Air Conditioners ?

Evaporator coil I believe I need to clean this but I cannot seem to find it. I climbed into my attict where the Ruud furnac/unit is located but did not know where to look


Answers :

Follow the copper line set from the condenser. Yhat will be the yellow brick road to tne evap coil.

Repair Help & Product Troubleshooting for Air Conditioners
You need a second opinion or clarification ? ask it in the comment box OR you can Ask Your Own Question

Tips for a great answer:

  • Please provide as much detail as possible as this will allow our members to better understand and respond to your Comment
  • If you need clarification, ask it in the comment box
  • It's 100% free, no registration required

Suggested Questions/Answers :

It is recommended you read all this kind of situations

Evaporator coil I believe I need to clean this but I cannot seem to find it. I climbed into my attict where the Ruud furnac/unit is located but did not know where to look


Follow the copper line set from the condenser. Yhat will be the yellow brick road to tne evap coil. ... Ruud UAKA030 Air Conditioner

Can someone tell me how to clean the flame sensor on my Ruud Sillohuette II Furnace. What does it look like exactly? I know you can clean it with a dollar bill or light steel wool but I don't know what exactly I'm looking at & how to take it out to cleanit


Ok, if you look at where the burners are, either to the far right or far left of the burners you will find a probe that sticks up or down in the flame of one burner. It will have only one wire going to it. That is the flame probe. You can scrub it wi ... Ruud UBHC Air Conditioner

Robert Shaw 2000 wiper gas valve quit working on a ruud, 50 ga. heater being used for floor heat. The spark looks weak. The pilot looks weak as well. All the pins are clean looking and wires appear to be attacked well. The unit was purchased in 2003, run for a couple of months before we figured out the application wouldn't work. We moved it to another location were it has worked fine for two seasons. Pilot and burner tubes are clear. Oriface in pilot tude is tough to blow through, but it is tiny


... Air Conditioners

Where can I find a manual for my coleman cam II central air conditioner for a mobile home? I recently purchased the mobile home and would like to know what steps to ntake to make it work at its best. Also, I find it puzzling that the air filter is set on top of the unit inside the mobile home. It looks to my limited knowledge of central air, as if someone set the filter on top of the unit because they did'nt know the correct location placement. Can you provide any comments or advice? Thanks


Check the website for Coleman/Intertherm for a manual, you will need the model and serial numbers of the unit. The filters for these typically sit on top of the unit, some come with frames, some lay directly on the coil. If you can't find a manual on ... Coleman Air Conditioners

I'm replacing a ac blower resistor on my 2004 Infiniti qx 56 but I don't know where it is located on the vehicle. I have taking the glove box out but I still have not found the location of the resistor. It is the one that looks like a credit card.


Try looking under hood ,near the firewall,passengers side near windshield, ... Air Conditioners

Hello, I am wondering what SEER rating my RUUD condenser unit is? Model # uafd 036-jas Serial # 4082 M3091 1291. I am looking to replace the system and the only unit I can find is a 13 SEER and I need to know if that will work with the air handler.


... Air Conditioners

I am looking for a Compressor for a Ruud Achiever 10 Seer 1.5 Tons. Does anyone know where I can purchase one? Thank you!


Hello, you should be able to purchase that compressor at any heating and cooling store in your area. As long as you have the model and serial number they will be able to help you out. ... Air Conditioners

I have a Kenmore 3-ton heat pump and the blower motor on the fan wont come on. I can let it cool off and spin it by hand to get it started. I suspect a startup capacitor but dont know where it is located or what it looks like. Any assistance would be greatly appreciated. It is 20 years old and this is the only problem I have had with it.


Hi,Yes it is the cap. and that looks like a round or oval metal container with wires coming out the top....look for the writing on the side and get one with the same mfd and voltage to replace it... mark the wires before removing and repl ... Kenmore 75085 Air Conditioner

I bought an ruud a/c about 6-7 yrs ago many problems i also have a 10 year warranty that covers all and the business went out of business and the a/c is failing and i dont know how to get the a/c fixed - someone said it looks like i might need a new a/c unit


Get the model and serial number on the outdoor unit, try to get ahold of\015\012Ruud, tell them you are having warranty issues and have them set you\015\012up with a Ruud dealer in your area. This will not cover labor cost and may cost mo ... Ruud UAKA037 Air Conditioner

I have an Intertherm T3BC unit that seems to frost up all the time and I never see it go into defrost mode. Is there a way of checking that the timer and or board is working? I know where both are located and they look fine. What settings should they be set at?


On the board there is a jumper it has writing marked 45 60 90 for amount of time to check for defrost\012set jumper to shorter time if it still does not defrost there is 2 pins that you short out to make it defrost if they dont make it defrost ... Intertherm P3RA-036K Air Conditioner

Need to know low pressure line is located - Ruud UBHC Air Conditioner


If it's an air conditioner and not a heat pump, the big line usually with a black rubber insulation on it is the low pressure line. ... Ruud UBHC Air Conditioner

I'm looking for a Compressor for a Ruud Achiever 10 Seer 1.5 Tons. Does anyone know where I can purchase one? Thank you!


Craigslist or EBAY depends . You would be better advised to purchase a new unit on-line usually the whole unit is about the same as a compressor and not nearly as much work. ... Air Conditioners

Drain must be blocked and water coming out of the front of the air conditoner. Would like to know how to dismantle to have a look and see if we can give it a clean. A Manual would be handy if possible thanks. Model No. on the Air Conditioner is AST12ASJCW. I was unable to locate it in the product below. Regards, Deb.


Heya Deb,I found the manuals that you where after. I have included a link below. Althou they dont really help with cleaning of the drain,http://www.fujitsugeneral.co.nz/manuals.pl?source=Hi-Wall+RangeIf you feel co ... Fujitsu 12C1 Air Conditioner

Looking for a Ruud 10 SEER condenser cabinet to replace


Nope ive been down that road nothing new try one of your local contractors they may have some thing used for cheap. Tom ... Air Conditioners

Multimeter Mastech, verses Fluke, Unfortunately I damaged my good old Fluke 87-3 when I measured a 3 phase motor supply while still in ohms mode, one of those o-**** moments when you hear the meter freak out and know without even looking at it. Still works but brain damaged and I don't trust it anymore. Anyway looking at various meters on the market and came across this mastech meter on ebay item 200461965472, I know its not a Fluke, but I like the features it boasts and of course the lower cost


I had a simial model and I can tell for sure that i is a pretty good tool ...the pairing with the laptop is great ..and have drivers for almost all operation systems...the issue with it is that indeed it has a slight delay ..but not that much to be a ... Air Conditioners

Where is the filter located to change on a Reem R-410A Refrigerant A/C I know it has to be washed but I do not know where it is located? Thank You, Mike


Is it a furnace or an air handler? ... Air Conditioners

A/C Unit SAMSUNG -Outdoor unit model= MH080FXCA 4A was connected to 3 indoor units: · B location – indoor unit model MH035FNCA · C location – indoor unit model MH035FNCA · D location – indoor unit model AQV18JA (This unit has no rotary switch SW02, so I don’t know how to set it for communication with the outdoor unit) I set the outdoor SW01 to 3, because 3 units are connected of possible 4. I moved the dip switch of the outdoor unit to “off” position. I set the indoo


... Samsung Air Conditioners

Changing filter on coleman AC located under RV. 2005 Dolphin . I don't know the location of the filter on my Coleman RV AC unit located under the RV. Also, I would like a maintenance and operation manual for the AC Unit.


\015\012COLEMAN R.V. PRODUCTS\015\012GO TO rvcomfort.com\015\012Click on RVP (RV PRODUCTS) \015\012Click on type of AC, if you can’t find the information you want there,\015\012then click on contact us on the Green ... Air Conditioners

Ruud uamc-048jaz I am looking for the spec sheet on this unit RUUD UAMC-048JAZ. I can't seem to find it on the Ruud Site. Seem like the unit in no longer in production. I need to get the condensing unit performance date for Air handler UBHC-21J11SFE ( Engeneering data Coil ID # RCGA-36A2) can someone please help with this Carl Diaz


I would strongly suggest you contact the Manufacturer DIRECT on this issue and let them provide you the information.RuudCustomer Service, Warranty and PartsPhone: 1-800-621-5622Available between 7:30AM - 5PM Central Standard Time ... Ruud Central System Air Conditioner

I'm looking into replacing my 2 ac systems. They're working fine but 13 years old. They're 4 tons ac systems with gas furnace. I've got quote from local RUUD dealer using RUUD ac UASL-048JEC, RUDD gas furnace RGPE-07EBRQR and coil by ADP (RES066GE2ISB2722AD). Is it ok to mix ADP coils with RUDD ac system or should I insist on using RUUD coil?


This really shouldn't make a difference... the point of the coils is just to transfer a fluid/gaseous medium and transmit temperature differences via their surface area. I'm sure if the ADP part is cheaper, it will be fine to use. They're ... Air Conditioners

About two years ago, I purchased a: Hunter 56 In. Brushed Nickel Ergonomic™ Remote Control Ceiling Fan Model 21871 A few months ago, a bolt of lightning struck through my house and my fan stopped working ever since then. The remote works fine since I can see the senson light up. And I know the electrical wiring is fine too because it was tested. However, I don't believe my fan is under warranty and I sm trying to find someone who could look at it and let me know if it's worth the mone


To have a contractor in your area look at this unit, try using the contractor search on the home page of fixYa, or simply use the yellow pages for your area.My guess is that the lighting burnt or damaged the motor windings in the fan. I a ... Hunter Air Conditioners

Hi i am try to wire a ruud system but i have a purple wire that i don't know where i have to connect to the thermostat and i have the same problem whit the condenser blue wire and purple can you explain me how to wire a ruud system please can you help me


The blue wire is common so the purple wire should be connected to the common on your tstat ... Ruud UBHC Air Conditioner

I want to see the way vacuum lines run & where each line connects to for factury a/c. Because I beleave that ( one out off 5 which I do not know the names of) is bad, and I no know where they are located for my 1967 deluxe interior Ford Mustang coupe.


Hi,The wiring diagram is :-http://www.wiringdiagrams21.com/wp-content/uploads/2008/11/ford-mustang-wiring-diagram.pngHope i helped you.Thanks for using ' Fixya ' and have a nice day!! ... Air Conditioners

We have an armstrong funace/ac package unit model 64hwc303a-2b. The repair contract i have on this system (my gas and elec co.) can't find the nozzles to recharge the system with the coolant, and don't have a manual on this unit. do you know where the service nozzles are located? do you know how i can get a copy of the manual besides the mfgr?


Hi, you have to contact Armstrong on 1-800-448-5872 : 8am-5pm EST directly to request for a copy of the manual and ask for any other information you need pertaining to the product, because you cannot get access to the manual anywhere online except f ... Air Conditioners

Working on a Carrier sx from 1990, has three wire bi-metal pilot with spark and 100% lockout on the spark module. Homeowner says it only fails in cold o.d. temps (less than 35 degrees). Home owner finds unit off and silent, resets 120v and unit re-lights and runs. Don't know what parts have been replaced so far but it looks like a new spark mod. and the pilot was clean but I cleaned it again. Limit switch looks old but I think limit failure would cause the blower to run. Any ideas?


Check the heater relay on the control board found in the blower part of this furnace. It's found in a steel enclosed box I'm having the same problem currently. I now have the blower running constantly set the thermostat to on not auto. until th ... Air Conditioners

A detailed question is important to get you a relevant answers

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
all rights reserved to the respective owners || www.ad-trader.net || Terms of Use || Contact || Privacy Policy
Load time: 0.0573 seconds