Having problems with your Air Conditioners ?

The remote keeps needing to be reset

\015 The remote control reset function indicates that the F1, F2, F3 & F4 corresponding numbers are lower than they should be. Currently they are each showing number 4.\015

Answers :

I would say the f1,f2,f3,f4, is speeds on the fan motor.If you turn the unit on to cool then I would say you need to keep the fan running all the time.But need to run it med-high or high speed to give good cooling.

Repair Help & Product Troubleshooting for Air Conditioners
You need a second opinion or clarification ? ask it in the comment box OR you can Ask Your Own Question

Tips for a great answer:

  • Please provide as much detail as possible as this will allow our members to better understand and respond to your Comment
  • If you need clarification, ask it in the comment box
  • It's 100% free, no registration required

Suggested Questions/Answers :

It is recommended you read all this kind of situations

The remote keeps needing to be reset


I would say the f1,f2,f3,f4, is speeds on the fan motor.If you turn the unit on to cool then I would say you need to keep the fan running all the time.But need to run it med-high or high speed to give good cooling. ... Air Conditioners

My Sharp CVP-12LX air conditioner keeps shutting off with the lights blinking. Usually this means the unit needs to be drained of water, but I have already done this. I reset the remote control and the unit's circut breaker but don't know what else to try. Suggestions would be greatly appreciated.


Hi there,\012Well,  It is a reminder to check the filter may be it needs cleaning. Once you have checked/cleaned the filter and reinstalled it, then reset it again using the remote control....Hope this resolves the issue.... ... Sharp CVP12LX Air Conditioner

Hi - our Siemens RDJ10RF remote thermostat controller fell off the shelf and went off as the batteries came loose. We put the batteries right and reset the thermostat remote, but the heating will not come on. Do we need to reset the boiler and how do we do it? The water still heats up, it is just the heating that doesnt respond to the thermostat anymore.


... Air Conditioners

The batteries been replaced in the remote- the LED screen indicates that there is power to the remote for a few seconds but then goes blank and the remote will not turn on the split system airconditioning. Have tried the reset button on the remote nothing changes. Do we need a new remote? Thanks for your help.


Try one more time with another new batteries and still the problem is, replace new remote. ... Air Conditioners

Anyone know how to reset the remote control for my everstar portable ac? I took the batteries out for the winter like the manual says, and when I put them back in this summer the remote came on but the AC no longer recognizes it. The manual says if I remove the batteries I will need to reprogram the remote, but it doesn't tell me how to do it!!! My AC model is MPN1-095CR-BB6 and the remote says Type R51I17/BGCE on the back. If anyone can help, thanks so much in advance!


... Danby DPAC8020 Air Conditioner

My A/C unit is not functioning properly. When switched on by remote or by power source, the left yellow light will come on for a few seconds, then the yellow indicator light on the right and middle orange light all begin flashing. I have tried everything - resetting the remote, on/off from the power source, on/off from the remote, and all with the same effect. I desperately need the A/C function to work as soon as possible and have been trying all day to make it work. Please help!


It will be helpful if you provide the manufacturer name and model no. of your air-conditioner.\015\012\015\012Do you hear the fan or the compressor run? ... Air Conditioners

My air conditioning unit wont start we usually start it with the remote but its not working it. it keeps flashing a symbol up the top when i try to turn it on but it wont start it. how can i fix the remote because i really need to get it started. the remote control unit model is: AR-DB5.


... Fujitsu 36CS Air Conditioner

Remote control on gas ducted heating V420I "4 star" keeps saying reset (have reset and reset at power box) unit switches off and then on


... Air Conditioners

We have a Weathermaker Split System A/C (indoor unit WMSI030H, outdoor unit WMSO030H). When going to switch on the A/C with the remote, the A/C is not receiving the signal; therefore not switching on. We have replaced the batteries, reset the remote, cleaned the sensor, but no luck.Anyhing else we can try or do we need to get our hands on a new remote?


... Carrier Air Conditioners

My panasonic air conditioner system keeps turning itself off and the timer light comes on flashing. The remote hasn't had the timer set. I have tried reseting the unit via the remote controll however it comes on for a split second and then turns back off again with the timer light flashing again. Can you please help?


... Air Conditioners

I purchased a Tower Quartz Heater about 16 or 18 months ago from Lowe's Home Improvement Store in Austell, Georgia. Now the weather has changed and I pluged it up and it will not work.I have tried the reset button and it still will not work. What do I need to do?I really would like to keep the heater. 1Touch The model #9200099004162. I really need this heater ASAP because I have a small baby in the house. Thank you for your assistance in this matter. My name is Elizabeth Maddox 4620 Hamlet


... Air Conditioners

Hi Guys, I work on a mine site and the temperature on my Mitsubishi model MSZ - 25GEVA split air con has been set and I cannot change it via the remote control. In any mode i.e. cool/ heat if you push the temperature buttons nothing happens. The remote works fine ON/ Off/ Fan etc but they've locked the temperature so it can't be changed. Even if I push the reset button the temperature still remains pre set. I'm of the thought that I might need to remove the batteries and hold done specific bu


... Mitsubishi MSZ09UN Air Conditioner

I have a miller oil furnace(cmf80) in a mobile home. The unit was working. Now the reset button keeps popping out after trying to start. you can hear a kind of ticking noise until the reset pops back out. I have a full tank, the filter is clean but no oil is coming out of the lines. I tried priming it but no oil comes out. I don't know if that's because you need the unit to be on in order to prime it. All I know is that there is no fire. Don't know if its the motor,pump or something else. I real


... Air Conditioners

When the unit is turned on it only stays on for a few seconds & then shuts down & turns off. No book left with unit when purchased the house so not sure of symbols on remote. (If needs to be reset). your advice muchly appreciated.


Your statement without error code mention, And hence, there are 2 reasons. Rotate blower motor manually. if rotate, replace your indoor sensor. If hard to rotate, problem with motor mechanism -locked. Replace bearings or motor. ... Air Conditioners

The remote doesn't respond despite new batteries and kicking to life when the reset button is pressed. Is it fixable or does it need replacin? Thanks


Transmission problem. Try with another same type remote. If still problem, receiving signal in PCB weak.Replace it. ... LG LS-J0910HL Heat & Cool Mini Split Air Conditioner

I have an outdoor Amana model# RCE42C2A air conditioner compressor unit. The pressure switch located on smaller tube (not sure if low side or high side) keeps needing to be reset, not sure if switch is the problem. Any suggestions?


... Amana Air Conditioners

When I turn on my RV Air Conditioner either manually or by remote control, the on green light comes on, but nothing else happens. Even the fan will not work. Is there a reset button I need to try and where is it?


Where is the green light that comes on? If it is not on the unit you may have a fuse or circuit breaker problem. check these if you hav ot already done so.\015\012Jim ... Air Conditioners

I need to reset my RAR-2P2 remote - Hitachi RAS-09UH Air Conditioner


... Hitachi RAS-09UH Air Conditioner

My Fujitsu (AST9LSACW ) timer light keeps flashing. the unit just blows air and dosen't cool regardless of setting. When I hit the test run button on the remote it flashes twice and I was told this means the temp setting control inside the unit needs replacing....what do you think???


Yes two flashes is indication of temp control setting problem.But still check this too:---\015\012This are other reasons of poor cooling:--\015\012\015\012? Is the Air Filter dirty?\015\012? Air the air conditioner's intake grille or outlet port bloc ... Fujitsu Air Conditioners

I OWN A 30K BTU PEIKARD CONSOLE FROM 2001. THE REMOTE CONTROL HAS GONE BERSERK. I CANNOT LEAVE THE BATTERIES ON BECAUSE IT KEEPS BLINKING ALL THE TIME. HELP!! I NEED ONE THAT WORKS!!!


... Sanyo 24KS72 Split System Air Conditioner

I have a ducted vulcan climate control gas heater unfortunately there is no visible model no the only info i have is VULCAN CENTRAL HEATING CLIMATE CONTROL ILEC .THE MANUAL IS ALSO NOT AVAILABLE. When the heater is switched on the flame and fan comes on but the flame does not stay alight for more than 10 to 15 secs after several attempts the reset indicator shows on the remote have tried switching on and off power and restarting several times only keeps blowing cool air


You should locate the flame sensor and clean it. Take a look: ... Air Conditioners

We have an alpha CB24 boiler . Fine with just hot water in summer. Once cold weather kicks in and we need heating the boiler keeps turning off completely and red light comes on. we reset and it comes back on for anything from 5 seconds to an hour. Th longer the day goes the shorter the time span. Please help this is diving me mad with turning on every few minutes.


It could be gas valve or the gas meter ... Air Conditioners

Alpha he cb33 keeps cutting out, if heating is on or we use hot water it cuts out, yellow light stops and red light flashes, we reset it and have heating for about 1/2 hr and then it cuts out again, engineer changed flow senor and it was all ok for a day but now problem is back, brrr need heat and hot water


... Air Conditioners

Panasonic split type aircon timer keeps on blinking. already reset the aircon and remote control but still it does not work.


... Panasonic CS-S9NKUW-1 Multi-System Wall-Mount Ductless A/C

I use a Harbor Breeze fan/light remote to operate a ceiling light. On the back of the remote it has this set of num/letters: FCCID KUJCE9103; It has three speeds for fan and On/Off/Dim for the light. The remote no longer operates the light. The 9 volt battery is good. The remote is stamped 2005. 10. when it passed inspection. Can I buy any remote that's similiar and assume the frequency is correct or do I need a specific one? If so, can u send me the one I need?


The receiver is dead. It doesn't have any batteries, and why would it? It operates on 110v household current. The receiver needs to be replaced. ... Air Conditioners

A detailed question is important to get you a relevant answers

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
all rights reserved to the respective owners || www.ad-trader.net || Terms of Use || Contact || Privacy Policy
Load time: 0.0635 seconds