Having problems with your Air Conditioners ?

My Honeywell ducted heating at home isn't working. I have set the on/off times for the week and set it to turn on automatically but nothing happens. I think the system is connected to the gas system outside (although I'm not 100% sure) and the gas water heater works so I assume the pilot light is working OK. Perhaps the fan or the fan motor has conked out? Any advice welcome! Thanks


Answers :

Its the thermostat problem .so its not heating .the thermostat is either cracked or dusty or needs readjust ment,
\015\012thanks.
\015\012

Repair Help & Product Troubleshooting for Air Conditioners
You need a second opinion or clarification ? ask it in the comment box OR you can Ask Your Own Question

Tips for a great answer:

  • Please provide as much detail as possible as this will allow our members to better understand and respond to your Comment
  • If you need clarification, ask it in the comment box
  • It's 100% free, no registration required

Suggested Questions/Answers :

It is recommended you read all this kind of situations

My Honeywell ducted heating at home isn't working. I have set the on/off times for the week and set it to turn on automatically but nothing happens. I think the system is connected to the gas system outside (although I'm not 100% sure) and the gas water heater works so I assume the pilot light is working OK. Perhaps the fan or the fan motor has conked out? Any advice welcome! Thanks


Its the thermostat problem .so its not heating .the thermostat is either cracked or dusty or needs readjust ment,\015\012thanks.\015\012 ... Honeywell Air Conditioners

Rinnai energysaver 556 wt: When I try to start it, I can hear the fan turn on, I can smell the gas, I can hear what I guess is the pilot light working, but it won't light. It shuts down before it ignites over half of the time. I have to keep restarting it. If I get it going, it works continuously so long as the room stays above 70F. If the temp drops below that then I need to repeat the aggravating process of starting it up again. I cannot depend on it when setting it to anything below 70 degree


... Rinnai RHFE-556WTA Direct Vent Heater NG Air Conditioner

Hi , I have a Electronic pilot lighting system on my RUUD package unit. The pilot light flame keeps blowing out or is not working properly. I removed the panel to look and see what was wrong. I could not see any faults. The sparker worked just fine, the gas line tubing was fine no blockages( took it off to inspect it) every thing looked good. Worked fine for the last couple of weeks and now it will not ignite the pilot light to light the rest of the propane gas to heat the house. I tested the fl


Sounds like you have checked most things. A pilot will go out if it is dirty, if the gas valve is not holding or if the senser is dirty or bad. Remove the pilot and clean out the small orifice inside. Check all electrical connections, clean the senso ... Ruud UBHC Air Conditioner

I am working on an older Williams gas wall heater. Pilot lights, heater comes on- after 1 hour cycles off, kills pilot light. one year ago installed new gas regtulator. DJWilson [email protected]


You have some limit switches located around the unit one high one or two around the middle one of them is opening and not closing. You need to take off the cover and locate the limits undo the wires and ohm them out you should have complete circuit ... Air Conditioners

My Carrier 58WAV136 forced air heater's problem is as follows - Thermostat works fine, when desired temp is reached, the fan motor (blower) kicks on. Sometimes it stays blowing for a couple of seconds, sometimes a minute. Often, the electric heating element will heat up and the gas furnace will light. But, the system will shut itself off within a few seconds and will try all over again. The LED sensor will blink 3 times fast, then one time. I do not have the manual to look this info up. Thanks f


There should be a code list inside the furnace panel access door. Find it and see what code 41 says, as I can't remember right off hand. Some of the possible causes could be air in gas line or low gas pressure. Could have blocked vent especialy if ve ... Carrier Air Conditioners

I HAVE A RUUD SILHOUETTE GAS FURNANCE. The pilot light keeps blowing out. When I light the pilot flame it seems to work perfectly at ignition. As the Manual instructs, I hold down the ignition switch for 30-60secs to keep the flame lit and then turn the gas switch to the on position. After watching the unit I have noted this happening - the furnance will begin the heat cycle sequence and pilot litghs all 4 burners correctly, the blower fan turns on, Heating starts. But after a short period, the


Short answer, yes. However you could have another problem. Replace the thermocouple that keeps the pilot lit. You can get a universal one at any good hardware or farm store. Make sure the new thermocouple is well into the pilot flame. If the blower ... Ruud UBHC Air Conditioner

Pilot light won't stay on when trying to switch on heater. Unit was serviced in August and was working recently. If the pilot light does stay on, it will eventually go out, so unable to use heater. It would appear that some adjustment has been set just 'on edge' as the heater was ok before servicing and cleaning. Baxi Brazilia 8000st


... Air Conditioners

My Johnson and Starley air flow heater is not working all the electrics are ok when started the solenoid on the Honeywell v8600c 1020 2 activated but no gas is supplied to the burners. The pilot light is working and after turning the gas off and on the pilot restarts and stays on constantly


Hi friend \015\012\015\012here is link for u\015\012http://www.fixya.com/support/honeywell ... Air Conditioners

Gas is going to cooking stove in camper. Stove lights. But can't get pilot to light for hot water heater. Don't smell gas coming to pilot area. Furnace is not turning on, but worked fine when checked a few months ago. any suggestions to try?


Chances are good that the thermocouple is bad. It is a small probe that the pilot light keep hot. Take it out and get one at HDepot or at a RV store. ... Air Conditioners

Reznor heater pilot light lights, gas valve clicks when thermstat turned up but burner does not light fan runs when power turned on why is fan on before burner lights?


... Air Conditioners

We have a residential Lochinvar Solution Boiler (model RBN090). Around 7 years old. For past 2 weeks pilot light keeps going out. 2 repairmen have come out. We have replaced the Gas regulator, the roll out switch, the thermocouple, and the pilot flame on the thermocouple. Pilot light continues to go out. No one has anwser. Pilot flame goes out sometimes when system is cold, other times after working for several hours and hot. Very random. But we have to relight serveral times per day a


... Air Conditioners

I have a sv9500m 2674 tha has a sticker that says it has been converted to L P gas. The ignitor lights the pilot and the fan comes on. The pilot stays lit and the main furnace fan comes on but the burner never fires. I have checked the electrical connections, cleaned the flame sensor that is on the ignitor (Q3400A1024) and cleaned the orafaces on the burner. I am thinking that the valve may be bad because the main furnace fan does activate which I assume is also controlled by the flame senso


Hello,If you cleaned the flame sensor and it is in the pilot flame,Try adding a ground wire from the pilot assembly to any close screw to boost the (pilot on) signal.Also if the valve has been sitting for a while give a tap once during (pilot on) to ... Honeywell Air Conditioners

The WeatherKing Forced air heater stopped working in my house. The thermostat could turn it on in terms of sound but when I looked at the heater, all I saw is the pilot light. No air, hot or cold, was being forced through the hour vents. Other than to remove the cover, I did nothing but now the pilot is off and there is no sound. I checked the house electric breakers and nothing was flipped off. This is a natual gas forced air heater made in 1983, model # GUWHE075A-D4C with 75000 input BTU per


You will need to relite the pilot if this is a standing pilot furnace........If this has an electronic lite for the pilot then cycle power to the furnace and set thermostat to heat. and retry sequence. Once you get the pilot to lite then watch it to ... Weather King Air Conditioners

I have had the gas off for two years. I got the pilot light to work but when I turn the thermostat up to get some heat it got the heater going about three times in over twenty-five tries over a couple


You need to clean the burner assembly. Over time dust and settled inside the unit and it is possibly restricting the flow of gas through the burners. This is a dangerous situation. get it cleaned before you try again. ... Air Conditioners

I have spark, I have gas, the fan is working, but will not light. Am I supposed to be using a propane regulator for this heater, or just direct from propane to inlet on the unit..... the solonoid is opening to allow the gas flow, spark is working for a short time after turning the switch on, just not firing.... do you think I need a new igniter, if so, where can I purchase one..... I would like to get a owner's manual for this unit.... thanks


Look 4 the brand name on unit and google it and i bet u will find all the info u need ... Air Conditioners

Gas heat does not always come on when it is switched on, when it does it works fine when it does not, the house is filled with a bad smell, I'm assuming unused gas. we have had the burners scrubbed with a wire brush before and no problems for 2 years. Can the burners just be replaced? Pilot light works fine. The furnace tries to come on, i can hear it clicking to ignite. Thanks Ronnie from Atlanta


You need to check gas vent ASAP. You should not be getting any odors from your furnace. Have a technician check your furnace. Could have hole in Heat exchanger. If so you and anyone else there are in danger. Please do not operate till it has been che ... Air Conditioners

We have a Rinnai 2000D heater. The pilot light goes out and is then difficult or impossible to restart. The igniter is working and there is the smell of gas, just doesnt seem to be enough gas there to ignite. Either that or the pilot is defective.


You can try cleaning the pilot light with sand paper, (where the hole in the end is where the gas comes out) they get carbon built up over time and causes the hole to get smaller which makes the pilot light not want to stay light because of the small ... Rinnai Air Conditioners

Have an old Rinnai Gas Heater (approximately 30 years old) still working well, but we had to turn off the gas, and now cannot turn it on again. We have two buttons, one below the other, one is red and say On, the other is black. We also have an ignition button at the side. However, we were under the impression that we had to push the red button to get the pilot alight, then hold it there for a few seconds for it to fire up BUT the pilot light does not stay on - just fades away. Can't find


You are half-way right, to light the pilot, light it and push down the red button and hold it for at ----least2-minutes-- till the flame heats up the pin (thermocouple- which fire-thermocouple metal makes electricity which sends it to the gas valve a ... Rinnai Air Conditioners

HI, we have Gas people here who need to check that our gas is working on ALL pilots in house and we have NO IDEA how to set the system up. we have been without gas for 2 days, our landlords are not responding to request for assistance and it would be FANTASTIC if you could please contact us with manual assistance! Thanks Kitty and Fraser we have gas people here waiting...and waiting 0433 809 231 or 0418576866


The gas people simply need to know where your gas appliance are. hot water heater, boiler, furnace, oven. A lot of gas equipment today, don't have pilots, they have electric igniters.\015\012\015\012The don't want to turn on your gas an ... Air Conditioners

I have a Rudd natural gas heater and central air system. The Air has been working fine all summer and now nothing works ,AC,heat and even the fan does not work. I tried changing the thermostat with no luck. Any suggestions. Thanks


Check for power at unit, as it may be the disconnect fuse/breaker. The only other thing is the main board, but it sounds like there is no power to the unit. I hope this helps Tim ... Ruud Air Conditioners

Hot water heater pilot Light wont light on my Bosh water wizard 600. Tried the manufactures process to reignite, but still will not light. The button with 3 flames is still depressed, and wont come out. Is this a problem? Gas is still on at the house, as my stove top works.


Hi,\015\012Yes you do have a problem with the button, the heater is broken.\015\012Turn the gas off to the unit and call to get it fixed as soon as you can.\015\012\015\012heatman101 ... Air Conditioners

I have a model HE424M 33Mj/h gas Pyrox Firestar gas heater. I have just cleaned it and now it does not start. The pilot light is ok as is the spark but as soon as I let go of the centre button tha whole thing goes out. I assume that it means I am getting no gas supply through


The pilot light has a thermocouple that allows gas to the pilot light while the flame is burning. If flame goes out it shuts gas off to the pilot jet. The thermocouple is bypassed by a switch during the initial ignition and once the thermoco ... Air Conditioners

The heater was working fine when we went to bed but in the morning we got up to find it had stopped working even though the thermostat showed the heat to be on.We checked the pilot flame and it is on.It is a reverse cycle Brivis Buffalo system(1984) model.The fan is alo working fine.


This is too deep to explain, so its best to call a service tech, with all his diagnostic tools Thank-you-very-much! ... Air Conditioners

We have recently bought a house with Vulcan ducted gas heating (no pilot light). When the system comes on it produces plenty of heat so I don't think there is anything wrong with the unit itself. Frequently, however, it reaches the set temperature, turns off, and then will not come back on even if we press the on/off button. The only way we can get it back on is to cut power to the house and then press the on button. That would suggest that there may be some kind of program set, but since


By the things you said here it seams that is nothing wrong with the device itself but it has something to do with the thermostat ...The thermostat is the part that it supposed to shut it down when the temperature gets to the set value....and also it ... Air Conditioners

Thremostat reaches and exceeds temperature setting but frunace continues to run, remove trermostat from wall and furnace continues to run. Not just fan- entire system, I have removed both panels from the furnaced itself and as soon as power is supplied the furnace immediately lights (gas) and begins to heat house. Current inside temperature is 77; set to heat to 70.


... Air Conditioners

A detailed question is important to get you a relevant answers

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
all rights reserved to the respective owners || www.ad-trader.net || Terms of Use || Contact || Privacy Policy
Load time: 0.1273 seconds